Table of Contents
Advertisement
User authentication
6. Assign the user to the admin group:
a. Click Groups.
b. For Add Group, click .
c. For Group, select the admin group.
d. Verify that the admin group has full administrator rights:
i. Click Authentication > Groups.
ii. Click admin.
iii. Verify that the admin group has Admin access enabled. If not, click Admin access to
enable.
iv. Verify that Access level is set to Full access. If not, select Full access.
e. Verify that Local users is one of the configured authentication methods:
i. Click Authentication > Methods.
ii. Verify that Local users is one of the methods listed in the list. If not:
ii. For Method, select Local users.
7. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.
Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Verify that the admin group has full administrator rights:
(config)> show auth group admin acl
admin
enable true
level full
...
(config)>
TX54 User Guide
i. For Add Method, click .
Example user configuration
556
Advertisement
Table of Contents
