Table of Contents
Advertisement
Wi-Fi
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure a Wi-Fi access point with personal security
The WPA and WPA2 personal security modes allow a Wi-Fi access point to authenticate clients by using
a preshared key that the client enters when connecting to the access point.
By default, the TX54 device comes with either one or two preconfigured access points:
Single-Wi-Fi models: Digi AP (Wi-Fi).
n
Dual-Wi-Fi models: Digi AP (Wi-Fi) and Digi AP (Wi-Fi2).
n
You cannot delete default access points, but you can modify them or you can create your own access
points.
Required configuration items
Enable the Wi-Fi access point
n
Select a Wi-Fi radio for the access point.
n
The Service Set Identifier (SSID) for the access point.
n
Configure security for the access point to WPA personal (PSK) or WPA2 personal (PSK).
n
The password (preshared key) that clients will used to connect to the access point.
n
LAN/bridge assignment. Once you configure a Wi-Fi access point, you must assign the Wi-Fi
n
access point to a LAN interface or to a bridge. See
more information.
Additional configuration items
Determine whether to broadcast the access point's SSID.
n
The amount of time to wait before changing the group key.
n
To configure a Wi-Fi access point with WPA personal (PSK) or WPA2 personal (PSK) security:
WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
TX54 User Guide
Configure a Wi-Fi access point with personal security
Configure a LAN
and
Configure a bridge
for
171
Advertisement
Table of Contents
