Digi TX54 User Manual page 312

Virtual Private Networks (VPN)
n
d. Set the IP address and optional netmask of the remote network. The keyword any can
also be used.
(config vpn ipsec tunnel ipsec_example policy 0)> remote network value
(config vpn ipsec tunnel ipsec_example policy 0)>
19. (Optional) Change the NAT keep alive time:
a. Change to the root of the configuration schema:
(config vpn ipsec tunnel ipsec_example policy 0)> ...
(config)>
b.
(config)> vpn ipsec advanced keep_alive value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set keep_alive to ten minutes, enter either 10m or 600s:
(config)> vpn ipsec advanced keep_alive 600s
(config)>
The default is 40 seconds.
20. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
21. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
TX54 User Guide
request: Requests a network from the remote peer.
IPsec
312