Example: Use A Ping Test For Wan Failover From Ethernet To Cellular - Digi TX54 User Manual

Interfaces

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Change to the WAN or WWAN's node in the configuration schema. For example, to disable
SureLink for the WWAN1 interface:
(config)> network interface wwan1
(config network interface wwan1)>
4. Determine the index number of the target:
(config network interface wwan1)> show ipv4 surelink target
0
interface_down_time 600s
interface_timeout 120s
test interface_up
1
test dns_configured
(config network interface wwan1)>
5. Delete the target:
(config network interface wwan1> del ipv4 surelink target 1
(config network interface wwan1)>
6. Save the configuration and apply the change:
(config network interface my_wwan ipv4 surelink)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Example: Use a ping test for WAN failover from Ethernet to cellular

In this example configuration, the WAN1 interface serves as the primary WAN, while the cellular
WWAN1 and WWAN2 interfaces, respectively, serve as the backup WANs. This example assumes a
TX54 User Guide
Wide Area Networks (WANs)
62