Table of Contents
Advertisement
Interfaces
(config)> network interface my_lan
(config network interface my_lan)>
4. Set the appropriate firewall zone:
(config network interface my_lan)> zone zone
(config network interface my_lan)>
See
Firewall configuration
5. Select an Ethernet device, a Wi-Fi device, or a bridge. See
bridging.
a. Enter device ? to view available devices and the proper syntax.
(config network interface my_lan)> device ?
Device: The network device used by this network interface.
Format:
/network/device/eth1
/network/device/eth2
/network/device/eth3
/network/device/eth4
/network/device/loopback
/network/bridge/hotspot_bridge
/network/bridge/lan1
/network/wireless/ap/digi_ap1
/network/wireless/ap/digi_ap2
/network/wireless/ap/digi_hotspot_ap1
/network/wireless/ap/digi_hotspot_ap2
Current value:
(config network interface my_lan)> device
b. Set the device for the LAN:
(config network interface my_lan)> device device
(config network interface my_lan)>
6. Configure IPv4 settings:
IPv4 support is enabled by default. To disable:
n
(config network interface my_lan)> ipv4 enable false
(config network interface my_lan)>
The LAN is configured by default to use a static IP address for its IPv4 configuration. To
n
configure the LAN to be a DHCP client, rather than using a static IP addres:
(config network interface my_lan)> ipv4 type dhcp
(config network interface my_lan)>
These instructions assume that the LAN will use a static IP address for its IPv4
configuration.
TX54 User Guide
for further information.
Local Area Networks (LANs)
Bridging
for more information about
108
Advertisement
Table of Contents
