Digi TX54 User Manual page 671

Monitoring
5. (Optional) Set the Wi-Fi channels that will be scanned by this instance of the service:
(config)> monitoring wifi_scanner channels value
(config)>
where value is a comma-separated list of channel numbers, or all to scan all channels. The
default is all.
6. (Optional) Set the frequency, in milliseconds, that the Wi-Fi scanner will hop from one channel
to the next during scanning:
(config)> monitoring wifi_scanner hop_frequency value
The default is 150.
7. (Optional) Set the number of seconds between scans.
(config)> monitoring wifi_scanner update_interval value
where value is any number of hours, minutes, or seconds, and takes the format number{h|m|s}.
For example, to set update_interval to ten minutes, enter either 10m or 600s:
(config)> monitoring wifi_scanner update_interval 600s
(config)>
The default is 15 seconds.
8. (Optional) Disable the use of the secondary Wi-Fi antenna:
(config)> monitoring wifi_scanner enable false
9. Enable the device to open an SSH port that remote hosts can access:
(config> monitoring wifi_scanner ssh enable true
(config)>
10. (Optional) Set the number of the port that the Wi-Fi scanner will use. The default is 3101.
(config)> monitoring wifi_scanner ssh port port
(config)>
11. Configure access control:
To limit access to specified IPv4 addresses and networks:
n
(config)> add wifi scanner ssh acl address end value
(config)>
Where value can be:
l
l
l
Repeat this step to list additional IP addresses or networks.
TX54 User Guide
A single IP address or host name.
A network designation in CIDR notation, for example, 192.168.1.0/24.
any: No limit to IPv4 addresses that can access the SSH service.
Enable the Wi-Fi scanner
671