Digi TX54 User Manual page 765

Command line interface
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add the WAN2 network interface:
(config)> add network interface WAN2
(config network interface WAN2)>
4. Enter device ? to view available devices and the proper syntax.
(config network interface WAN2)> device ?
Device: The network device used by this network interface.
Format:
/network/device/eth1
/network/device/eth2
/network/device/eth3
/network/device/eth4
/network/device/loopback
/network/bridge/LAN2
/network/bridge/lan1
/network/wireless/ap/digi_ap1
/network/wireless/ap/digi_ap2
Current value:
(config network interface WAN2)> device
5. Configure the WAN to use the eth4 device:
(config network interface WAN2)> device /network/device/eth4
(config network interface WAN2)>
6. Change the zone for the WAN to external:
(config network interface WAN2)> zone external
(config network interface WAN2)>
7. Configure the WAN as an IPv4 DHCP client:
a. Enter ipv4 ? to determine the available settings for ipv4 (the appropriate setting is
highlighted in the example output):
(config network interface WAN2)> ipv4 ?
IPv4
Parameters
TX54 User Guide
Current Value
Configuration mode
765