Configure A Wireless Wide Area Network (Wwan) - Digi TX54 User Manual

Interfaces
connection_monitor
(config network interface my_wan)>
d. Modify any of the remaining default settings as appropriate. For example, to change the
metric:
(config network interface my_wan)> ipv6 metric 1
(config network interface my_wan)>
If the minimum length is not available, then a longer prefix will be used.
See Configure WAN/WWAN priority and default route metrics
metrics.
8. Save the configuration and apply the change:
(config network interface my_wan)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure a Wireless Wide Area Network (WWAN)

Configuring a Wireless Wide Area Network (WWAN) involves configuring the following items:
Required configuration items
The interface type: Modem.
n
The firewall zone: External.
n
The cellular modem that is used by the WWAN.
n
Additional configuration items
SIM selection for this WWAN.
n
The SIM PIN.
n
The SIM phone number for SMS connections.
n
Enable or disable roaming.
n
DNS options.
n
SIM failover configuration.
n
APN configuration.
n
The custom gateway/netmask.
n
IPv4 configuration:
n
The metric for IPv4 routes associated with the WAN.
l
The relative weight for IPv4 routes associated with the WAN.
l
TX54 User Guide
Active recovery
Wide Area Networks (WANs)
for further information about
89