Digi TX54 User Manual page 604

Firewall
ix. Set the destination address type:
(config network qos 2 policy 0 rule 0)> dst type value
(config network qos 2 policy 0 rule 0)>
where value is one of:
TX54 User Guide
where value uses the format IPv6_address[/prefix_length], or any to match
any IPv6 address.
mac: Only traffic from the MAC address typed in MAC address will be matched.
n
Set the MAC address to be matched:
(config network qos 2 policy 0 rule 0)> src mac MAC_address
(config network qos 2 policy 0 rule 0)>
any: Traffic destined for anywhere will be matched.
n
See Firewall configuration
interface: Only traffic destined for the selected Interface will be matched. Set
n
the interface:
i. Use the ? to determine available interfaces:
(config network qos 2 policy 0 rule 0)> dst interface ?
Interface: Match the IP address with the specified
interface's network address.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/lan1
/network/interface/lan_hotspot
/network/interface/loopback
/network/interface/wan1
/network/interface/wwan1
/network/interface/wwan2
Current value:
(config network qos 2 policy 0 rule 0)> dst interface
ii. Set the interface. For example:
(config network qos 2 policy 0 rule 0)> dst interface
/network/interface/wan1
(config network qos 2 policy 0 rule 0)>
address: Only traffic destined for the IP address typed in IPv4 address will be
n
matched. Set the address that will be matched:
(config network qos 2 policy 0 rule 0)> src address value
(config network qos 2 policy 0 rule 0)>
where value uses the format IPv4_address[/netmask], or any to match any
IPv4 address.
Configure Quality of Service options
for more information about firewall zones.
604