Digi TX54 User Manual page 125

Interfaces
of the IP address will be based on the LAN's static IP address as defined in the Address field.
Allowed values are between 1 and 254, and the default is 100 for Lease range start and 250
for Lease range end.
9. Optional DHCP server settings:
a. Click to expand Advanced settings.
b. For Gateway, select either:
n
n
n
The default is Automatic.
c. For MTU,
n
n
n
The default is Automatic.
d. For Domain name suffix, type the domain name that should be appended to host names.
e. For Primary and Secondary DNS, Primary and Secondary NTP server, and Primary and
Secondary WINS server, select either:
n
n
n
f. For Bootfile name, type the relative path and file name of the bootfile on the TFTP server.
g. For TFTP server name, type the IP address or host name of the TFTP server.
10. See Configure DHCP options
11. See Map static IP addresses to hosts
12. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
TX54 User Guide
None: No gateway is broadcast by the DHCP server. Client destinations must be
resolvable without a gateway.
Automatic: Broadcasts the TX54 device's gateway.
Custom: Allows you to identify the IP address of a Custom gateway to be
broadcast.
None: An MTU of length 0 is broadcast. This is not recommended.
Automatic: No MTU is broadcast and clients will determine their own MTU.
Custom: Allows you to identify a Custom MTU to be broadcast.
None: No server is broadcast.
Automatic: Broadcasts the TX54 device's server.
Custom: Allows you to identify the IP address of the server.
for information about Custom DHCP options.
for information about Static leases.
Local Area Networks (LANs)
125