Digi TX54 User Manual page 670

Monitoring
n
n
11. Confirm that users who will use the Wi-Fi scanner server are members of an authentication
group that has Wi-Fi scanner access enabled. See
authentication group configuration information.
12. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable the Wi-Fi scanner:
(config> monitoring wifi_scanner enable true
(config)>
4. Set the appropriate Wi-Fi radio (dual Wi-Fi models only):
(config)> monitoring wifi_scanner radio value
(config)>
where value is either wifi1 or wifi2.
TX54 User Guide
To limit access to hosts connected through a specified interface on the TX54 device:
i. Click Interfaces.
ii. For Add Interface, click .
iii. For Interface, select the appropriate interface from the dropdown.
iv. Click  again to allow access through additional interfaces.
To limit access based on firewall zones:
i. Click Zones.
ii. For Add Zone, click .
iii. For Zone, select the appropriate firewall zone from the dropdown.
See Firewall configuration
iv. Click  again to allow access through additional firewall zones.
for information about firewall zones.
Add an authentication group
Enable the Wi-Fi scanner
for
670