Digi TX54 User Manual page 768

Hide thumbs Also See for TX54:

Table of Contents

Command line interface

192.168.3.* subnet.

c. Verify that the device has access to the internet.

4. Verify that WAN priority and failover are operating correctly between WAN1 and WAN2:

a. Connect an Ethernet cable from an alternate internet-connected modem to WAN2 through

the ETH4 Ethernet port.

b. Verify that when both WANs are connected to the internet, devices connected to the TX54

have internet access through WAN1.

c. Verify that failover functions correctly between WAN1 and WAN2:

i. Disconnect the WAN1 Ethernet cable from the WAN/ETH1 Ethernet port and verify

that devices connected to the TX54 have internet access through WAN2.

ii. Reconnect the WAN1 Ethernet cable to the WAN/ETH1 Ethernet port and verify that

devices connected to the TX54 have internet access through WAN1.

d. Verify that failover functions correctly if both WAN1 and WAN2 are not working:

i. Insert at least one SIM in one of the cellular modems.

ii. When the WWAN's Service LED indicates that the device is connected to the cellular

network, unplug both the WAN1 Etherent cable from the WAN/ETH1 Ethernet port,

and the WAN2 Ethernet cable from the ETH4 Ethernet port.

iii. Verify that devices connected to the TX54 have internet access through the WWAN.

TX54 User Guide

Configuration mode