Digi TX54 User Manual page 53

Interfaces
To configure the TX54 device to reboot when an interface has failed:

WebUI
SureLink can be configured for both IPv4 and IPv6.
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Create a new interface or select an existing one:
To create a new interface, see
n
or Configure a Wireless Wide Area Network
To edit an existing interface, click to expand the appropriate interface.
n
5. After creating or selecting the interface, click IPv4 (or IPv6) > SureLink.
6. Enable SureLink.
SureLink can be enabled for both IPv4 and IPv6 configurations. By default, SureLink is enabled
for IPv4 for the preconfigured WAN (WAN1) and WWANs (WWAN1 and, for dual-cellular models,
WWAN2). It is disabled for IPv6.
7. Enable Reboot device.
8. Click to expand Test targets.
TX54 User Guide
Configure a LAN, Configure a Wide Area Network
(WWAN).
Wide Area Networks (WANs)
(WAN),
53