Example: Configure Multiple Wans And Lans By Using The Command Line - Digi TX54 User Manual

Command line interface
serial
acl
(config auth user user1)>
6. Add the user to the admin group:
(config auth user user1)> add group end admin
(config auth user user1)>
7. Save the configuration and apply the change:
(config auth user user1)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Example: Configure multiple WANs and LANs by using the command
line
The default configuration of the TX54 consists of one WAN (WAN1), one or two Wireless WANs (WWAN
for single-cellular models, WWAN1 and WWAN2 for dual-cellular models), and one LAN (LAN1). The
WANs are configured to use the following devices:
TX54 User Guide
portal
enable false
no portals
serial
enable false
no ports
shell
enable false
admin
enable true
nagios
enable false
openvpn
enable false
no tunnels
portal
enable false
no portals
serial
enable true
ports
0 port1
shell
enable false
Configuration mode
758