Configure A Wi-Fi Client And Add Client Networks - Digi TX54 User Manual

Wi-Fi
2. At the Admin CLI prompt, type show wifi ap name name:
> show wifi ap name my_AP
Enabled
Status
SSID
Security
Channel
Channel Width
Radio
BSSID
Client
-----------------
cc:c0:78:34:d5:a2
>

Configure a Wi-Fi client and add client networks

Required configuration items
Create the Wi-Fi client.
n
The TX54 device's Wi-Fi radio that the Wi-Fi client will use.
n
The Wi-Fi network that the client will log into:
n
SSID of the Wi-Fi network's access point.
l
Type of security, and user name and/or password if applicable, used by the access point.
l
WAN assignment. Once you configure a Wi-Fi client, you must assign the Wi-Fi client to a WAN.
n
See Wide Area Networks (WANs) and Wireless Wide Area Networks (WWANs)
information.
Additional configuration items
Enable and configure background scanning, which allows the Wi-Fi client to move between
n
access points that have the same SSID as their signal strength varies.
Additional access points that client will attempt to use. If connection to one access point fails,
n
the device will attempt to connect to the next access point in the list.
To configure a Wi-Fi client:

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
TX54 User Guide
Configure a Wi-Fi client and add client networks
: true
: up
: my_AP
: none
:
:
: wifi1
: 01:41:D1:14:36:37
Signal RX TX
------ ------ ------
-68 260997 279481
Uptime
------
801
for further
185