Digi TX54 User Manual page 277

Routing
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type
> show route
Destination
Interface
------------------------
- ------------------------
default
10.1.14.25
/network/device/eth1
10.1.14.27
/network/device/eth1
10.1.25.0/24
/network/device/eth1
127.0.0.0/8
/network/device/loopback
fd00:2704::1
fd00:2704::/64
fd00:2704::/48
2147483647
fe80::204:f3ff:fe80:e231
fe80::204:f3ff:ff80:c525
fe80::/64
fe80::/64
default
default
IPv4 Route
----------
wan1
wwan1
IPv6 Route
----------
wan1
wwan1
>
You can limit the display to only IPv4 entries by using show route ipv4, or to IPv6 entries by
using show route ipv6. You can also display more information by adding the verbose option to
the show route and show route ip_type commands.
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
TX54 User Guide
show route:
Gateway
------------------------
10.1.21.1
10.1.21.1
10.1.21.1
fe80::204:f3ff:fe80:e231
fe80::204:f3ff:fe80:e231
fe80::204:f3ff:fe80:e231
fe80::204:f3ff:fe80:e231
Load Balance (%)
----------------
75.0
25.0
Load Balance (%)
----------------
75.0
25.0
Show the routing table
Source Metric
----------- ---------
1
10.1.21.99 1
10.1.21.99 1
10.1.21.99 1
127.0.0.1
1
1
1
1
256
256
1
1024
277