Digi TX54 User Manual page 627

System administration
c. Reset the default password for the admin account. See
default admin user

Command line
1. Log into the TX54 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the following:
> system factory-erase
3. After resetting the device:
a. Connect to the TX54 by using the serial port or by using an Ethernet cable to connect the
TX54 LAN1 port to your PC.
b. Log into the TX54:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
c. Reset the default password for the admin account. See
default admin user
Reset the device by using the RESET button.
1. Locate the RESET button on your device.
2. Press and hold the RESET button perform a device reset. The RESET button has two modes:
Configuration reset:
n
l
l
Full device reset:
n
l
l
3. After resetting the device:
a. Connect to the TX54 by using the serial port or by using an Ethernet cable to connect the
TX54 LAN1 port to your PC.
TX54 User Guide
for further information.
for further information.
Press and hold the RESET button for 10 seconds.
The device reboots automatically and resets to factory defaults. This does not
remove any automatically generated certificates and keys.
After the device reboots from the first button press, immediately press and hold the
RESET button for 10 seconds again.
The device reboots again and resets to factory defaults, as well as also removing
generated certificates and keys.
Reset the device to factory defaults
Reset default password for the
Reset default password for the
627