Configure The Hotspot To Use Radius Users Authentication - Digi TX54 User Manual

Hotspot
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure the hotspot to use RADIUS users authentication

RADIUS users authentication requires each hotspot user to enter a username and password. Users
are created on an external RADIUS server, and the username and password is validated by the
external RADIUS server.
By default, the router redirects unauthenticated users to the HTML authentication page located on
the router at etc/config/hotspot/login.html. You can customize the authentication page as needed,
or host an authentication page on a remote server. See
information.
Required configuration items
Create a new hotspot
n
Select RADIUS users authentication.
n
IP address or hostname of the primary RADIUS server.
n
Users configured on the RADIUS server.
n
RADIUS server secret.
n
RADIUS NAS ID.
n
Domain name or subnet of the RADIUS server included in the "white list" of servers that
n
unauthenticated hotspot clients can access.
Additional configuration items
IP address or hostname of the secondary RADIUS server to be used if the primary
n
RADIUS server is unreachable.
Modify the local HTML authentication page, /etc/config/hotspot/login.html, or enter the
n
name of an alternative HTML authentication page stored in the same directory, or identify a
remote web server to host the HTML authentication page and include that server in the "white
list" of servers that unauthenticated hotspot clients can access. See
login page
Hotspot LAN configuration:

Configure hotspot for RADIUS users authentication from the WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
TX54 User Guide
or Enable hotspot using the default
for further information.
Hotspot configuration
Customize the hotspot login page
configuration.
Customize the hotspot
for further
232