Show Wan And Wwan Status And Statistics - Digi TX54 User Manual

Interfaces
b. IPv6 support is enabled by default. To disable:
(config network interface my_wwan)> ipv6 enable false
(config network interface my_wwan)>
c. Set the metric.
(config network interface my_wwan)> ipv6 metric num
(config network interface my_wwan)>
See Configure WAN/WWAN priority and default route metrics
metrics.
d. Set the relative weight for default routes associated with this interface. For multiple active
interfaces with the same metric, the weight is used to load balance traffic to the
interfaces.
(config network interface my_wwan)> ipv6 weight num
(config network interface my_wwan)>
e. Set the management priority. This determines which interface will have priority for central
management activity. The interface with the highest number will be used.
(config network interface my_wwan)> ipv6 mgmt num
(config network interface my_wwan)>
f. Set the MTU.
(config network interface my_wwan)> ipv6 mtu num
(config network interface my_wwan)>
g. See Configure SureLink active recovery to detect WAN/WWAN failures
about configuring active recovery.

Show WAN and WWAN status and statistics


WebUI
1. Log into the TX54 WebUI as a user with Admin access.
2. From the menu, click Status.
3. Under Networking, click Interfaces.

Command line
1. Log into the TX54 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
TX54 User Guide
Wide Area Networks (WANs)
for further information about
for information
98