Set The Idle Timeout For Tx54 Users - Digi TX54 User Manual

Hide thumbs Also See for TX54:

Table of Contents

User authentication

5. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Set the idle timeout for TX54 users

To configure the amount of time that the user's active session can be inactive before it is

automatically disconnected, set the Idle timeout parameter.

By default, the Idle timeout is set to 10 minutes.

1. Log into the TX54 WebUI as a user with full Admin access rights.

2. On the menu, click System. Under Configuration, click Device Configuration.

The Configuration window is displayed.

3. Click Authentication.

4. For Idle timeout, enter the amount of time that the active session can be idle before the user

is automatically logged out.

Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the

format number{w|d|h|m|s}.

For example, to set Idle timeout to ten minutes, enter 10m or 600s.

5. Click Apply to save the configuration and apply the change.

TX54 User Guide

Set the idle timeout for TX54 users