Table of Contents
Advertisement
Interfaces
3. Configure active recovery on WAN1:
a. Click Network > Interface > WAN1 > IPv4 > SureLink.
b. For Interval, type 10s.
c. Click to expand Test targets.
d. Delete the existing test targets:
Click the menu icon (...) next to each target and select Delete.
e. For Add Test Target, click .
f. For Test type, select Ping test.
g. For Ping host, type 43.66.93.111.
h. For Ping payload size, type 256.
4. Repeat the above step for WWAN1 and WWAN2 to enable SureLink on those interfaces.
5. Configure WWAN1 to have priority over WWAN2. The default configurations for WWAN1 and
WWAN2 both have the metric set to 3, while WAN1 has a metric of 1. To configure WWAN1 to
have priority over WWAN2 and continue to be serve as a backup to WAN1, WWAN1's metric
should be set to 2.
a. Click Network > Interface > WWAN1 > IPv4.
b. For Metric, type 2.
6. Click Apply to save the configuration and apply the change.
TX54 User Guide
Wide Area Networks (WANs)
64
Advertisement
Table of Contents
