Configure Power Delays For Power Ignition Sensor - Digi TX54 User Manual

Hide thumbs Also See for TX54:

Table of Contents

System administration

b. Log into the TX54:

User name: Use the default user name: admin.

Password: Use the unique password printed on the bottom label of the device (or the

printed label included in the package).

c. Reset the default password for the admin account. See

default admin user

Reset the device with the revert command

You can reset the device to the default configuration without removing scripts, keys, and logfiles by

using the revert command:

1. Log into the TX54 command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. At the config prompt, enter revert:

(config)> revert

4. Set the password for the admin user prior to saving the changes:

(config)> auth user admin password pwd

5. Save the configuration and apply the change:

(config)> save

Configuration saved.

6. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Configure power delays for power ignition sensor

By default, the TX54 device automatically powers on when it detects power on the ignition sensor, and

powers off when it detects that there is no power on the ignition sensor, and there is no delay for

either power on or power off based on the power ignition sensor.

You can configure delays for powering on or off the system based on the state of the ignition sensor.

TX54 User Guide

Configure power delays for power ignition sensor

for further information.

Reset default password for the