Use A Dead Reckoning External Usb Gnss Receiver - Digi TX54 User Manual

Services
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Use a dead reckoning external USB GNSS receiver

The TX54 device supports an external USB GNSS receiver to provide dead reckoning-based location
information. The USB GNSS receiver is available for purchase from Digi International Inc..
The ability to use an external USB GNSS receiver is enabled by default. After purchasing the
USB GNSS receiver, plug it into a USB port on the TX54, and it will begin providing location information.
Note If both the internal GNSS module and the external dead reckoning USB receiver are used
simultaneously, the TX54 device will determine the device's location by using the source that returns
the information first. Therefore, if you want to guarantee that the dead reckoning USB receiver is
used to return the device's location, you should either remove the GNSS antenna from the device, or
disable the internal GNSS module. See
information.
To disable support for the external GNSS receiver, or enable it if it has been disabled:

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Location.
4. Click Enable USB GNSS module to disable the USB GNSS receiver, or to enable it if it has been
disabled.
TX54 User Guide
Enable or disable the internal GNSS module
Location information
for further
436