Digi TX54 User Manual page 521

User authentication
l
The default is Full access full.
Shell access
n
Shell access is not available if the Allow shell parameter has been disabled. See
shell access
Serial access
n
6. (Optional) Configure OpenVPN access. See for further information.
7. (Optional) Configure captive portal access:
a. Enable captive portal access rights for users of this group by checking the box next to
Captive portal access.
b. Click Captive portals to expand the Captive portal node.
c. For Add Captive portal, click .
d. In the Captive portal dropdown, select a captive portal to which users of this group will
have access.
e. Click  again to add additional captive portals.
8. (Optional) Enable users that belong to this group to query the device for Nagios monitoring by
checking the box next to Nagios access.
9. (Optional) Enable users that belong to this group to access the Bluetooth scanning service by
checking the box next to Bluetooth scanner access.
10. (Optional) Enable users that belong to this group to access the Wi-Fi scanning service by
checking the box next to Wi-Fi scanner access.
11. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Use the add auth group command to add a new authentication. For example, to add a group
named test:
TX54 User Guide
Read-only access read-only: provides users of this group with read-only access to
the WebUI and Admin CLI.
for more information about the Allow shell parameter.
Authentication groups
Disable
521