Configure The Internal Gnss Module - Digi TX54 User Manual

Services
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure the internal GNSS module

The internal GNSS module is enabled by default. You can disable it, or you can enable it if it has been
disabled.
Note In order for the internal GNSS module to be able to provide location information, you must
connect an antenna to the GNSS antenna connector.

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Location > Location sources > gnss.
4. Click Enable the location source to disable the internal GNSS module, or to enable it if it has
been disabled.
Alternatively, you can also delete the gnss location source:
a. Click the menu icon (...) next to the gnss location source
b. Click Delete.
TX54 User Guide
Location information
588