Digi TX54 User Manual page 175

Wi-Fi
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Edit an existing Access point
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Show available access points:
(config)> network wifi ap ?
Additional Configuration
--------------------------------------------------------------------------
-----
digi_ap1
digi_ap2
(config)>
4. Set the SSID for the appropriate access point:
(config)> network wifi ap digi_ap1 ssid my_SSID
(config)>
5. SSID broadcasting is enabled by default for the preconfigured access points. If SSID
broadcasting is disabled:
(config)> network wifi ap digi_ap1 ssid_broadcast true
(config)>
6. Set the security for the access point to psk or psk2 :
(config)> network wifi ap digi_ap1 encryption type psk2
(config)>
7. Set the password that clients will use when connecting to the access point:
(config)> network wifi ap digi_ap1 encryption key_psk2 password
(config)>
8. (Optional) Change the Wi-Fi radio for the access point (dual-Wi-Fi models only):
TX54 User Guide
Configure a Wi-Fi access point with personal security
Digi AP (Wi-Fi1)
Digi AP (Wi-Fi2)
175