Digi TX54 User Manual page 444

Services
3. Click Services > Location.
4. Location features are enabled by default. If they have been disabled, enable the appropriate
features:
Click Enable the location server to forward information that the TX54 device receives
n
from external location sources. See
from external sources
Click Enable GNSS module to forward the device's location information based on its
n
GNSS module.
5. (Optional) For Location update interval, type the amount of time to wait to forward location
information to remote hosts. The default is ten seconds.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Location update interval to ten minutes, enter 10m or 600s.
6. Click Destination servers.
7. For Add destination server, click .
8. (Optional) For Label, type a description of the location destination server.
9. For Destination server, enter the hostname or IP address of the remote host to which
location messages will be sent.
10. For Destination server port, enter the UDP port on the remote host to which location
messages will be sent.
11. For Outgoing message type, select the protocol type for the messages, either TAIP or NMEA.
12. (Optional) For NMEA and TAIP filters, select the filters that represent the types of messages
that will be forwarded. By default, all message types are forwarded.
To remove a filter:
n
a. Click the down arrow () next to the appropriate message type.
b. Click Delete.
To add a message type:
n
a. For Add NMEA filter or Add TAIP filter, click .
b. Select the message type.
Allowed values depend on the protocol type:
TX54 User Guide
Configure the device to accept location messages
for more information.
Location information
444