Configure An Openvpn Client Without Using An .Ovpn File - Digi TX54 User Manual

Virtual Private Networks (VPN)
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure an OpenVPN client without using an .ovpn file

Required configuration items
Enable the OpenVPN client.
n
The OpenVPN client is enabled by default.
The mode used by the OpenVPN server, either routing (TUN), or bridging (TAP).
n
The firewall zone to be used by the OpenVPN client.
n
The IP address of the OpenVPN server.
n
Certificates and keys:
n
The CA certificate (usually in a ca.crt file).
l
The Public key (for example, client.crt)
l
The Private key (for example, client.key).
l
Additional configuration items
The route metric for the OpenVPN client.
n
The login credentials for the OpenVPN client, if configured on the OpenVPN server.
n
Additional OpenVPN parameters.
n
See Configure active recovery for OpenVPN

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
TX54 User Guide
for information about OpenVPN active recovery.
OpenVPN
350