Digi TX54 User Manual page 161

Wi-Fi
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the channel for the radio:
a. Determine available radios:
(config)> network wifi radio ?
Additional Configuration
-----------------------------------------------------------------------
--------
wifi1
wifi2
(config)> network wifi radio
b. Determine the band for the appropriate radio:
(config)> network wifi radio wifi band
2400mhz
(config)>
c. Set the channel for the Wi-Fi radio:
(config)> network wifi radio wifi 2400mhz channel value
(config)>
where value is:
n
n
TX54 User Guide
For 2.4 GHz:
1 through 11
l
auto
l
For 5 GHz:
Configure the Wi-Fi module channel
Wi-Fi1 radio
Wi-Fi2 radio
161