Digi TX54 User Manual page 107

Interfaces
g. For Weight, type the relative weight for default routes associated with this interface. For
multiple active interfaces with the same metric, Weight is used to load balance traffic to
the interfaces.
h. Set the Management priority. This determines which interface will have priority for
central management activity. The interface with the highest number will be used.
i. Set the MTU.
11. (Optional) Click to expand MAC address blacklist.
Incoming packets will be dropped from any devices whose MAC addresses is included in the
MAC address blacklist.
a. Click to expand MAC address blacklist.
b. For Add MAC address, click .
c. Type the MAC address.
12. (Optional) Click to expand MAC address whitelist.
If there whitelist entries are specified, incoming packets will only be accepted from the listed
MAC addresses.
a. Click to expand MAC address whitelist.
b. For Add MAC address, click .
c. Type the MAC address.
13. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new LAN or edit an existing one:
To create a new LAN named my_lan:
n
(config)> add network interface my_lan
(config network interface my_lan)>
To edit an existing LAN named my_lan, change to the my_lan node in the configuration
n
schema:
TX54 User Guide
Local Area Networks (LANs)
107