Enable Or Disable A Packet Filtering Rule - Digi TX54 User Manual

Firewall
where value is one of:
any
n
icmp
n
icmpv6
n
tcp
n
upd
n
The default is any.
9. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Enable or disable a packet filtering rule

To enable or disable a packet filtering rule:

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Firewall > Packet filtering.
4. Click the appropriate packet filtering rule.
TX54 User Guide
Packet filtering
582