Digi TX54 User Manual page 661

Hide thumbs Also See for TX54:

Table of Contents

3. Click Monitoring > Bluetooth scanner.

4. Click Enable.

5. (Optional) For Update interval, type the amount of time that the record of a device connection

is kept before the device is considered out of range, and the record is expired from the

Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the

format number{w|d|h|m|s}.

For example, to set Update interval to ten minutes, enter 10m or 600s.

The minimum value is 5 seconds, and the default is 15 seconds.

6. Configure the device to open an SSH port that remote hosts can access:

a. Click to expand SSH stream service.

b. Click Enable.

c. (Optional) For Port, type the port that the Bluetooth scanner will use. The default is 3102.

d. Click Access control list to configure access control:

TX54 User Guide

To limit access to specified IPv4 addresses and networks:

i. Click IPv4 Addresses.

ii. For Add Address, click .

iii. For Address, enter the IPv4 address or network that can access the device's

SSH service. Allowed values are:

Enable the Bluetooth scanner