Table of Contents
Advertisement
Interfaces
j. Configure the source address:
i. Set the source type to interface:
(config network route policy 1)> src type interface
(config network route policy 1)>
ii. Set the interface to LAN2:
(config network route policy 1)> src interface LAN2
(config network route policy 1)>
k. Configure the destination address:
i. Set the type to interface:
(config network route policy 1)> dst type interface
(config network route policy 1)>
ii. Set the interface to WWANPrivate :
(config network route policy 1)> interface
/network/interface/WWANPrivate
(config network route policy 1)>
6. Save the configuration and apply the change:
(config network route policy 1)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
TX54 User Guide
Wide Area Networks (WANs)
81
Advertisement
Table of Contents
