Digi TX54 User Manual page 518

User authentication
6. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable or disable access rights for the group. For example:
Admin access:
n
l
TX54 User Guide
To set the access level for Admin access of the admin group:
(config)> auth group admin acl admin level value
(config)>
where value is either:
full: provides users of this group with the ability to manage the TX54 device by
o
using the WebUI or the Admin CLI.
read-only: provides users of this group with read-only access to the WebUI and
o
Admin CLI.
The default is full.
Authentication groups
518