Show Vrrp Status And Statistics - Digi TX54 User Manual

Routing
(config network vrrp new_vrrp_instance)> priority int
(config network vrrp new_vrrp_instance)>
8. (Optional) Set a password that will be used to authenticate this VRRP router with VRRP peers.
If the password length exceeds 8 characters, it will be truncated to 8 characters.
(config network vrrp new_vrrp_instance)> password pwd
(config network vrrp new_vrrp_instance)>
9. Add a virtual IP address associated with this VRRP instance. This can be an IPv4 or IPv6
address.
(config network vrrp new_vrrp_instance)> add virtual_address end ip_address
(config network vrrp new_vrrp_instance)>
Additional virtual IP addresses can be added by repeating this step with different values for ip_
address.
10. Save the configuration and apply the change:
(config network vrrp new_vrrp_instance)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show VRRP status and statistics

This section describes how to display VRRP status and statistics for a TX54 device. VRRP status is
available from the Web UI only.

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
TX54 User Guide
Virtual Router Redundancy Protocol (VRRP)
287