Delete An Authentication Group - Digi TX54 User Manual

Hide thumbs Also See for TX54:

Table of Contents

User authentication

ii. Add a captive portal:

(config)> add auth group test acl portal portals end portal1

6. (Optional) Configure Nagios monitoring:

(config)> auth group test acl nagios enable true

7. (Optional) Enable users that belong to this group to access the Bluetooth scanning service:

(config)> auth group test acl bluetooth_scanner enable true

8. (Optional) Enable users that belong to this group to access the Wi-Fi scanning service:

(config)> auth group group test acl wifi_scanner enable true

9. Save the configuration and apply the change:

(config)> save

Configuration saved.

10. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Delete an authentication group

By default, the TX54 device has two preconfigured authentication groups: admin and serial. These

groups cannot be deleted.

To delete an authentication group that you have created:

TX54 User Guide

http redirect

no interface

no redirect_url

Authentication groups