Mount The Tx54 To A Mounting Surface; Connect Power - Digi TX54 User Manual

Hardware setup
Wi-Fi-1 and Wi-Fi-2 (Wi-Fi enabled models only).
n
WWAN-1 and WWAN-2.
n

Mount the TX54 to a mounting surface

Mount the TX54 device to a mounting surface by using the two mounting brackets. The mounting
brackets are preinstalled when the device is delivered.
Tighten self-tapping screws to the mounting surface through the mounting holes of mounting
brackets.
Note The mounting screw specifications are: Roundhead M4 size screws or comparable non-metric (6-
32 size). Type and length is dependent on the mounting surface type.

Connect power

Connect the TX54 power cable to a power source.
Vehicle installation
The TX54 shall be powered from a 5 A fused circuit or shall be installed with an in-line Slow Blow fuse
rated at 5 A.
Maximum ambient operating temperature is limited to 74°C.
TX54 User Guide
Mount the TX54 to a mounting surface
24