Table of Contents
Advertisement
Services
5. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.
Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable or disable the USB GNSS receiver:
To enable the USB GNSS receiver:
n
(config)> service location usb true
(config)>
To disable the USB GNSS receiver:
n
(config)> service location usb false
(config)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the device to accept location messages from external
sources
You can configure the TX54 device to accept NMEA or TAIP messages from external sources. For
example, location-enabled devices connected to the TX54 device can forward their location
information to the device, and then the TX54 device can serve as a central repository for this location
information and forward it to a remote host. See
information about configuring the TX54 device to forward location messages.
This procedure configures a UDP port on the TX54 device that will be used to listen for incoming
messages.
TX54 User Guide
Forward location information to a remote host
Location information
for
437
Advertisement
Table of Contents
