Digi TX54 User Manual page 220

Hotspot
(config network bridge new_hotspot_bridge)> .. .. interface lan1
device ?
Device: The network device used by this network interface.
Format:
Default value: /network/bridge/lan1
Current value: /network/bridge/lan1
(config network bridge new_hotspot_bridge)>
ii. Add the appropriate device. For example, to add the Digi AP (Wi-Fi) Wi-Fi access
point:
(config network bridge new_hotspot_bridge)> add device end
/network/wireless/ap/digi_ap1
(config)>
c. Type ... to return to the config prompt:
(config network bridge new_hotspot_bridge)> ...
(config)>
d. Create an interface for the bridge:
(config)> add network interface hotspot_bridge_interface
(config network interface hotspot_bridge_interface)>
e. Add the new bridge to the interface:
(config network interface hotspot_bridge_interface)> device
/network/bridge/new_hotspot_bridge
(config network interface hotspot_bridge_interface)>
f. Set an IP address for the interface.
Note This IP address is not the IP address of the hotspot. The hotspot IP address is
configured during hotspot configuration.
TX54 User Guide
/network/device/eth1
/network/device/eth2
/network/device/eth3
/network/device/eth4
/network/device/loopback
/network/bridge/hotspot_bridge
/network/bridge/lan1
/network/wireless/ap/digi_ap1
/network/wireless/ap/digi_ap2
/network/wireless/ap/digi_hotspot_ap1
/network/wireless/ap/digi_hotspot_ap2
Hotspot configuration
220