Mount The Tx54 To A Mounting Surface; Connect Power - Digi TX54 User Manual

Hide thumbs Also See for TX54:

Table of Contents

Hardware setup

Wi-Fi-1 and Wi-Fi-2 (Wi-Fi enabled models only).

WWAN-1 and WWAN-2.

Mount the TX54 to a mounting surface

Mount the TX54 device to a mounting surface by using the two mounting brackets. The mounting

brackets are preinstalled when the device is delivered.

Tighten self-tapping screws to the mounting surface through the mounting holes of mounting

The mounting screw specifications are: Roundhead M4 size screws or comparable non-metric (6-

32 size). Type and length is dependent on the mounting surface type.

Connect the TX54 power cable to a power source.

Vehicle installation

The TX54 shall be powered from a 5 A fused circuit or shall be installed with an in-line Slow Blow fuse

rated at 5 A.

Maximum ambient operating temperature is limited to 74°C.

Always follow the vehicle manufacturer recommendations for electrical accessories connections.

All components used in the electrical connection to the vehicle should be UL listed. See also

Alternate installations

The TX54 shall be powered by a Certified ITE LPS power supply or a Direct Plugin Class 2 output

transformer rated at either 12 VDC/2.5 A or 24 VDC/1.25 A minimum. Supplies shall be suitable for the

ambient for which they are installed.

TX54 User Guide

Mount the TX54 to a mounting surface