Connect Data Cables; Mount The Ix10 Device; Attach To A Mounting Surface By Using The Two Mounting Tabs; Attach To Din Rail With Clip - Digi IX10 User Manual

Hardware setup
Move the device to another location.
n
Try connecting a different set of antennas, if available.
n
Purchase a Digi Antenna Extender Kit:
n

Connect data cables

The IX10 provides two types of data ports:
Ethernet (RJ-45): Use a Cat 5e or Cat 6 Ethernet cable.
n
Serial (RJ-50): Use a serial cable with an RJ-50 connector to connect to the IX10 device. See
n
10-pin serial cabling options

Mount the IX10 device

There are three options for mounting the IX10 device:
Attach to a mounting surface by using the two mounting
n
Attach to DIN rail with
n

Attach to a mounting surface by using the two mounting tabs

Attach to DIN rail with clip

The DIN rail clip is an optional accessory included when the IX10 is purchased with accessories. You
can attach the din rail clip directly to the device either on the back or the bottom of the device.
IX10 User Guide
Antenna Extender Kit,
for information about Digi's 10-pin RJ-50 cables.
clip.
Connect data cables
1m.
tabs.
28