Show System Output Details - Enterasys G3G170-24 Cli Reference Manual

show system
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display system information:
G3(su)->show system
System contact:
System location:
System name:
Power Supply 1 Status
---------------------
Ok
Fan Group 1-Status
------------------
Ok
Fan Group 3-Status
------------------
Ok
Thermal Sensor
--------------
Fixed Slot
Power Supply Redundancy
-----------------------
Enabled
Uptime d,h:m:s
--------------
4,22:9:13
Table provides an explanation of the command output. Refer to the G‐Series Installation Guide for
information on the location of system hardware components.
Table 2-4 show system Output Details
Output Field
System contact
System location
System name
Power Supply 1 Status
Power Supply 2 Status
2-12 Basic Configuration
Power Supply 2 Status
---------------------
Not Installed
Fan Group 2-Status
------------------
Ok
Thermal Threshold
-----------------
37%
Logout
-------
0 min
What It Displays...
Contact person for the system. Default of a blank string can be changed with the
set system contact command
Where the system is located. Default of a blank string can be changed with the
set system location command
Name identifying the system. Default of a blank string can be changed with the
set system name command
Operational status for the power supply in the PWR1 slot.
Operational status for the power supply in the PWR2 slot.
("set system contact" on page 2-23).
("set system location" on page 2-23).
("set system name" on page 2-22).