Ipv6 Nd Ns-Interval; Ipv6 Nd Reachable-Time - Enterasys G3G170-24 Cli Reference Manual

ipv6 nd ns-interval

Example
This example changes the number of consecutive Neighbor Solicitation messages sent for DAD to
3 on this interface.
G3(su)->router(Config-if(Vlan 1))# ipv6 nd dad attempts 3
ipv6 nd ns-interval
This command configures the interval between Neighbor Solicitations sent on an interface.
Syntax
ipv6 nd ns-interval {msec | 0}
no ipv6 nd ns-interval
Parameters
msec
0
Defaults
By default, a value of 0 is advertised in RA messages.
Mode
Router interface configuration:G3(su)‐>router(Config‐if(Vlan 1))#
Usage
The NS interval is used to determine the time between retransmissions of neighbor solicitation
messages to a neighbor when resolving a unicast address (DAD) or when probing the reachability
of a neighbor. This value is also advertised in Router Advertisement (RA) messages sent on the
interface.
Use the no form of this command to set the interval to the default of 0.
Example
This example sets the NS interval to 2 seconds.
G3(su)->router(Config-if(Vlan 1))# ipv6 nd ns-interval 2000

ipv6 nd reachable-time

This command configures the length of time within which some reachability confirmation must be
received from a neighbor for the neighbor to be considered reachable.
Syntax
ipv6 nd reachable-time msec
no ipv6 nd reachable-time
18-14 IPv6 Configuration
Sets the interval in milliseconds between retransmissions of Neighbor
Solicitation messages on the interface. The value can range from 1000
(one second) to 3,600,000 (one hour) milliseconds.
An advertised value of 0 means the interval is unspecified.