Mode
Interface configuration: G3
Example
This example shows how to enable IRDP on the VLAN 1 interface:
G3(su)->router(Config)#interface vlan 1
G3(su)->router(Config-if(Vlan 1))#ip irdp enable
ip irdp maxadvertinterval
Use this command to set the maximum interval in seconds between IRDP advertisements. The no
form of this command resets the maximum advertisement interval to the default value of 600
seconds.
Syntax
ip irdp maxadvertinterval interval
no irdp maxadvertinterval
Parameters
interval
Defaults
None.
Mode
Interface configuration: G3
Example
This example shows how to set the maximum IRDP advertisement interval to 1000 seconds on the
VLAN 1 interface:
G3(su)->router(Config)#interface vlan 1
G3(su)->router(Config-if(Vlan 1))#ip irdp maxadvertinterval 1000
ip irdp minadvertinterval
Use this command to set the minimum interval in seconds between IRDP advertisements. The no
form of this command deletes the custom holdtime setting, and resets the minimum
advertisement interval to the default value of three‐fourths of the maxadvertinterval value, which
is equal to 450 seconds.
Syntax
ip irdp minadvertinterval interval
no irdp minadvertinterval
(su)‐>router(Config‐if(Vlan 1))#
Specifies a maximum advertisement interval in seconds. Valid values are
4 to 1800.
(su)‐>router(Config‐if(Vlan 1))#
ip irdp maxadvertinterval
Enterasys G-Series CLI Reference 16-35