Ping Ipv6 Interface - Enterasys G3G170-24 Cli Reference Manual

size num
Defaults
None.
Mode
Router privileged exec: G3(su)‐>router#
Router user exec: G3(su)‐>router>
Usage
Use this command to determine whether another computer is on the network. To use this
command, configure the switch for network (in‐band) connection. The source and target devices
must have the ping utility enabled and running on top of TCP/IP.
The switch can be pinged from any IP workstation with which the switch is connected through the
default VLAN (VLAN 1), as long as there is a physical path between the switch and the
workstation. The terminal interface sends three pings to the target station.
Examples
This example shows output from a successful ping to IPv6 address 2001:0db8:1234:5555::1234:1.
G3(su)->router#ping ipv6 2001:0db8:1234:5555::1234:1
Send count=3, Receive count=3 from 2001:DB8:1234:5555::1234:1
Average round trip time = 1.00 ms
This example shows output from an unsuccessful ping to IPv6 address
2001:0db8:1234:5555::1234:1.
G3(su)->ping ipv6 2001:0db8:1234:5555::1234:1
no answer from 2001:DB8:1234:5555::1234:1

ping ipv6 interface

Use this command to test routing network connectivity by sending IP ping requests.
Syntax
ping ipv6 interface {vlan vlan-id | tunnel tunnel-id | loopback loop-id}
{link-local-address ipv6-lladdr | ipv6-addr} [size num]
Parameters
vlan vlan‐id
tunnel tunnel‐id
loopback loop‐id
link‐local‐address
ipv6‐lladdr
ipv6‐addr
(Optional) Specifies the size of the datagram packet. The value of num can
range from 48 to 2048 bytes.
Specifies a VLAN interface as the source.
Specifies a tunnel interface as the source.
Specifies a loopback interface as the source.
Specifies a link‐local IPv6 address to ping.
Specifies the global IPv6 address of the system to ping. Enter the address
in the form documented in RFC 4291, with the address specified in
hexadecimal using 16‐bit values between colons.
ping ipv6 interface
Enterasys G-Series CLI Reference 18-7