Parameters
port‐string
Defaults
If the port‐string is not specified, the QoS setting of all physical ports will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display the current algorithm and transmit queue weights configured
on port
G3(su)->show port txq ge.1.10
Port
-----
ge.1.10 WRR 10
set port txq
Use this command to set QoS transmit queue arbitration values for physical ports.
Syntax
set port txq port-string value0 value1 value2 value3 value4 value5 value6 value7
Parameters
port‐string
value0 ‐ value7
Defaults
None.
Mode
Switch command, read‐write.
(Optional) Specifies port(s) for which to display QoS settings. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐1.
Only physical ports will be displayed. LAG ports have no transmit queue
information.
ge
.1.10:
Alg
Q0
Q1
Q2
Q3
--- --- --- --- --- --- --- --- ---
10
15
20
Specifies port(s) on which to set queue arbitration values. For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 4‐1.
Only physical ports can be configured with this command. LAG ports
cannot be configured.
Specifies percentage to allocate to a specific transmit queue. The values
must total 100 percent.
Q4
Q5
Q6
Q7
25
20
0
0
set port txq
Enterasys G-Series CLI Reference 9-7