Syntax
ip irdp preference preference
no irdp preference
Parameters
preference
Defaults
None.
Mode
Interface configuration: G3
Example
This example shows how to set IRDP preference on the VLAN 1 interface so that the interface's
address may still be advertised, but cannot be used by neighboring hosts as a default router
address:
G3(su)->router(Config)#interface vlan 1
G3(su)->router(Config-if(Vlan 1))#ip irdp preference -2147483648
ip irdp broadcast
Use this command to configure IRDP to use the limited broadcast address of 255.255.255.255. The
default is multicast with address 224.0.0.1. The no form of this command resets IRDP to use
multicast on IP address 224.0.0.1.
Syntax
ip irdp broadcast
no ip irdp broadcast
Parameters
None.
Defaults
None.
Mode
Interface configuration: G3
Example
This example shows how to enable broadcast for IRDP on the VLAN 1 interface:
G3(su)->router(Config)#interface vlan 1
G3(su)->router(Config-if(Vlan 1))#ip irdp broadcast
Specifies the value to indicate the interface's use as a default router
address. Valid values are ‐2147483648 to 2147483647.
The minimum value indicates that the address, even though it may be
advertised, is not to be used by neighboring hosts as a default router
address.
(su)‐>router(Config‐if(Vlan 1))#
(su)‐>router(Config‐if(Vlan 1))#
ip irdp broadcast
Enterasys G-Series CLI Reference 16-37