Parameters
ipv4‐addr
interface vlan vlan‐id
Defaults
None.
Mode
Router interface configuration: G3(su)‐>router(Config‐if(Tnnl 1))#
Usage
The no form of this command removes the source IPv4 address for the tunnel interface being
configured.
Example
The following example configures the source IPv4 address for tunnel 1.
G3(su)->router(Config)# interface tunnel 1
G3(su)->router(Config-if(Tnnl 1))#
(su)->router(Config-if(Tnnl 1))# tunnel source 192.168.10.10
G3
tunnel destination
This command specifies the IPv4 destination transport address of the tunnel.
Syntax
tunnel destination ipv4-addr
no tunnel destination
Parameters
ipv4‐addr
Defaults
None.
Mode
Router interface configuration: G3(su)‐>router(Config‐if(Tnnl 1))#
Usage
The no form of this command removes the destination IPv4 address for the tunnel interface being
configured.
Example
The following example configures the destination IPv4 address for tunnel 1.
G3(su)->router(Config)# interface tunnel 1
G3(su)->router(Config-if(Tnnl 1))#
(su)->router(Config-if(Tnnl 1))# tunnel destination 192.168.10.20
G3
The IPv4 source address of the tunnel.
Specify an interface to use a link‐local address. The VLAN must be
configured in switch mode.
The IPv4 destination address of the tunnel.
tunnel destination
Enterasys G-Series CLI Reference 15-9