Show Ipv6 Ospf Neighbor Output Details - Enterasys G3G170-24 Cli Reference Manual

The information is displayed only if OSPFv3 is enabled and the interface has a neighbor.
Examples
This example illustrates the summary information displayed when no neighbor is specified.
G3(su)->router#show ipv6 ospf neighbor
Router ID
----------------
3.3.3.3
6.6.6.6
Table 19‐9 provides an explanation of the command output.
Table 19-9 show ipv6 ospf neighbor Output Details
Output Field
Router ID
Priority
Intf ID
Interface
State
Dead Time
Priority Intf Interface
ID
-------- ----- -----------
1 3 Vlan 36
1 456 Tunnel 0
What It Displays...
The 4-digit dotted-decimal number of the neighbor router.
OSPFv3 priority for the specified interface. The priority of an
interface is a priority integer from 0 to 255. A value of '0' indicates
that the router is not eligible to become the designated router on
this network.
Interface ID of the neighbor.
Interface of the local router.
State of the neighboring routers. Possible values are:
• Down- initial state of the neighbor conversation - no recent
information has been received from the neighbor.
• Attempt - no recent information has been received from the
neighbor but a more concerted effort should be made to
contact the neighbor.
• Init - a Hello packet has recently been seen from the neighbor,
but bidirectional communication has not yet been established.
• 2 way - communication between the two routers is bidirectional.
This is the final state between two routers, both of which are
non-designated routers or back-up designated routers.
• Exchange start - the first step in creating an adjacency between
the two neighboring routers, the goal is to decide which router
is the master and to decide upon the initial DD sequence
number.
• Exchange - the router is describing its entire link state database
by sending Database Description packets to the neighbor.
• Loading - Link State Request packets are sent to the neighbor
asking for the more recent LSAs that have been discovered
(but not yet received) in the Exchange state.
• Full - the neighboring routers are fully adjacent and they will
now appear in router-LSAs and network-LSAs.
Amount of time, in seconds, to wait before the router assumes the
neighbor is unreachable.
show ipv6 ospf neighbor
State Dead
Time
---------------- ----
Full/DR 32
Full/PtP 31
Enterasys G-Series CLI Reference 19-41