Clear Dhcp Pool Bootfile; Set Dhcp Pool Next-Server - Enterasys G3G170-24 Cli Reference Manual

Mode
Switch command, read‐write.
Example
This example sets the boot image filename for address pool named "auto1."
G3(rw)->set dhcp pool auto1 bootfile image1.img

clear dhcp pool bootfile

Use this command to remove a default boot image from the address pool being configured.
Syntax
clear dhcp pool poolname bootfile
Parameters
poolname
Defaults
None.
Mode
Switch command, read‐write.
Example
This example removes the boot image filename from address pool named "auto1."
G3(rw)->clear dhcp pool auto1 bootfile

set dhcp pool next-server

Use this command to specify the file server from which the default boot image is to be loaded by
the client.
Syntax
set dhcp pool poolname next-server ip-address
Parameters
poolname
ip‐address
Defaults
None.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the IP address of the file server the DHCP client should contact
to load the default boot image.
clear dhcp pool bootfile
Enterasys G-Series CLI Reference 13-19